Trying out the instrument
R&S
®
SMB100B
47Getting Started 1422.1045.02 ─ 06
a) Set "Start Freq > 200 MHz" and "Stop Freq > 600 MHz" to determine the
frequency sweep range.
b) Set the step width "Step Lin > 10.0 MHz" to determine the width for a fre-
quency step.
6. In the "General" tab, activate the frequency sweep with "State > On".
7. Close the sweep dialog.
(Alternatively, tap the "Home" button to minimize the dialog. The
R&S SMB100B indicates the "Sweep" dialog as active dialog in the task bar.)
8. To activate the RF signal output, select "Level" > "RF On".
Figure 6-2: Generating a frequency sweep signal
The frequency field in the status bar indicates the continuously changing fre-
quency, i.e. the running sweep.
6.3 Saving and recalling settings
To restore the results of our measurements later, we save the instrument settings
in a file.
Saving and recalling settings
To Next Page
Loading...
