Trying out the instrument
R&S
®
SMB100B
46Getting Started 1422.1045.02 ─ 06
a) Select "Mode > Auto" to run the sweep continuously.
b) Select "Shape > Sawtooth" to set the waveform shape of the sweep signal.
c) Select "Spacing > Linear", to determine the calculation method for the fre-
quency shift of a step.
d) Set "Dwell Time > 15.0 ms", to determine the time interval of the sweep
steps.
5. Select the "Frequency Range" tab.
Generating an RF frequency sweep signal
To Next Page
Loading...
