Instrument tour
R&S
®
SMB100B
36Getting Started 1422.1045.02 ─ 06
5.1.7 RF 50 Ω
Output of the RF signal (N female connector).
How to: Chapter 4.10, "Connecting to RF 50 Ω", on page 28
5.1.8 Keypad
The keypad enables you to enter alphanumeric parameters, including the corre-
sponding units. It contains the following keys:
Table 5-6: Keys on the keypad
Type of key Description
Alphanumeric keys Enter numbers and (special) characters in edit dialog boxes.
Decimal point Inserts a decimal point "." at the cursor position.
Sign key Changes the sign of a numeric parameter. For an alphanumeric
parameter, inserts a "-" at the cursor position.
Unit keys
(G/n dBμV, M/μ μV, k/m mV
and x1 dB(m))
These keys add the selected unit to the entered numeric value
and complete the entry.
For level entries (e.g. in dB) or dimensionless values, all units
have the value "1" as multiplying factor. Thus, they have the
same function as an [Enter] key.
5.1.9 On/Standby
The [On/Standby] key switches the instrument from the standby to the ready state
or vice versa.
The LED above the [On/Standby] key indicates the instrument state, see Chap-
ter 4.12, "Switching on or off", on page 29.
5.2 Rear panel tour
This section provides an overview of the connectors at the rear panel of the
instrument. For technical data of the connectors, refer to the data sheet.
Rear panel tour
To Next Page
Loading...
