Instrument tour
R&S
®
SMB100B
37Getting Started 1422.1045.02 ─ 06
1 2 3 4 5 6
8111213141516
7
9
10
Figure 5-3: Rear panel view R&S
SMB100B RF Signal Generator
1 = Serial number (six digits in the string 1400.1000.02-<serial number>-<checksum>)
2 = IEC 625/IEEE 488
3, 5 = USB/USB In
4 = LAN
6 = AC power supply connector and switch
7 = S/P Dif
8 = Stereo L/R
9, 10 = Ref In/Ref Out
11 = LF
12 = Mod. Ext.
13 = Pulse Video
14 = Pulse Ext.
15 = Signal Valid
16 = Inst Trig
5.2.1 Connectors
IEC 625/IEEE 488
Option: R&S SMBB-B86
General purpose interface bus (GPIB) interface for remote control of the instru-
ment. The interface is in compliance with the standards IEC 625, IEEE 488 and
SCPI.
Use this interface to connect a computer for remote control of the R&S SMB100B.
To set up the connection, use high-quality shielded cables. See "Cable selection
and electromagnetic interference (EMI)" on page 23.
Rear panel tour
To Next Page
Loading...
