Instrument tour
R&S
®
SMB100B
39Getting Started 1422.1045.02 ─ 06
How to: Chapter 4.11, "Connecting to Ref In/Ref Out", on page 28
LF
BNC connector for output of the internal LF generator signal.
See the data sheet and in the user manual, section "Analog modulation".
Mod. Ext.
BNC connector for input of external analog modulation signals.
Pulse Video
BNC connector for output of the internal pulse generator signal or the looped
through pulse signal from Pulse Ext. connector (video signal).
Pulse Ext.
BNC connector for input of an external pulse modulation signal or an external trig-
ger/gate signal for the pulse generator.
Signal Valid
BNC connector for output of a signal that determines the valid signal times (valid
level and frequency) for all analog modulations.
Alternatively, you can use this connector to synchronize pulse signals by activat-
ing "Pulse Sync Out", see "Analog modulations > Modulation settings > Pulse
generator > Pulse generator settings" in the user manual.
Inst Trig
BNC connector for input of external trigger signals. The signals trigger sweeps
and list mode.
See chapter "Signal generation and triggering in the sweep and list modes" in the
user manual.
Rear panel tour
To Next Page
Loading...
