Rohde & Schwarz R&S SMB100B - Generating an RF Frequency Sweep Signal

Trying out the instrument
R&S
®
SMB100B
45Getting Started 1422.1045.02 ─ 06
Connect RF 50 Ω of the R&S SMB100B to a signal analyzer, for example
R&S
®
FSW, to display the generated signal.
For the required settings of the signal analyzer, refer to its user manual or its
online help.
6.2 Generating an RF frequency sweep signal
The "Sweep" operating mode allows you to generate an RF signal with periodi-
cally varying frequencies or amplitudes.
This example deals with an RF signal with varying frequency and constant level.
To configure the sweep, you need to determine a defined start and end frequency
with constant time intervals between the frequency steps.
The sweep function does not require specific options.
1. On the front panel, press the [Preset] key to set a defined initial instrument
state.
2. Set the signal output level, if required, e.g. set "Level > -25 dBm".
3. In the tile diagram, select "Sweep" > "Frequency Sweep".
4. In the "General" tab:
Generating an RF frequency sweep signal