Trying out the instrument
R&S
®
SMB100B
49Getting Started 1422.1045.02 ─ 06
2. Press the [Setup] key on the front panel.
3. In the "Setup" menu, select "Settings > Save/Recall".
4. In the "Save/Recall" dialog, select "Operation Mode > Recall".
Navigate to the directory the file is saved in and select the MyTestSignal
file.
5. Tap the "Recall" button.
All instrument settings are restored and the display resembles Chapter 6.2,
"Generating an RF frequency sweep signal", on page 45, which shows the
instrument display right before the settings were saved.
How to display all parameters with values different to their preset val-
ues
When you load a file to your instrument, you do not have enough informa-
tion on the changed settings. In such case, it is useful to visualize all param-
eters that have been changed from their default state.
Saving and recalling settings
To Next Page
Loading...
