18
Quick Memory
One Touch Setting
This function allows you to save virtually all panel settings to a registra-
tion memory. You can instantly recall these settings by pressing a single
button.
Note: The registered memory will be lost when the power turns o.
Registering the Panel Settings
1. The memory function is turned on by default when the power is turned
on.
2. When this function is turned o, you can press the [QUICK MEMORY]
button to turn this function on, the “MEMORY” icon on LCD lights up.
3. Press and hold the [QUICK MEMORY] button, then press one of the
memory buttons [1] ~ [4] to save the panel settings to that button.
Note: It will overwrite the previous data saved in that button.
4. Parameters that can be saved to registration memory include:
Tone: main tone, dual tone, split tone, DSP eects, mixer settings.
Accompaniment: style, tempo, chord mode.
Function: touch response and some parameters in the function menu.
Recalling the Registered Settings
Press one of the memory buttons [1] ~ [4].
It will recall the settings saved in that button. This will reset related pa-
rameters on the control panel.
Notes:
1. By default, the four memory slots are empty when the power is turned
on. If you press a memory button, the LCD will display “Empty” to
indicate there’s no data.
2. Registration memory cannot be recalled when the O.T.S. function is in
use.
When one touch setting function is in use, you can instantly recall the relat-
ed tone settings to match the current style with a single touch of a button.
1. Press the [O.T.S.] button. The “O.T.S.” icon on LCD lights up.
If chord mode is turned o, the A.B.C. function will be turned on auto-
matically.
If the WHOLE mode is turned on, it will stay in WHOLE mode when
O.T.S. is engaged.
2. Press one of the O.T.S. buttons [1]–[4]. It will recall the tone and eect
settings that match the selected style.
O.T.S. parameters include:
Main tone: volume, reverb level, octave.
Dual tone: volume, reverb level, octave.
Split tone: volume, reverb level, octave.
3. Press the [O.T.S.] button again to turn o this function.
It will automatically switch to registration memory. The “MEMORY” icon
on LCD lights up.
Note:
Registration memory is not available when O.T.S. is in use.