6
Setup
This section contains information about setting up your instrument and
preparing to play. Please go through this section carefully before turning
the power on.
Power Supply
You can power the instrument by using the included power adaptor or by
using batteries.
Turn down the volume of the instrument and the connected audio equip-
ment before you switch the instrument on.
Using Power Adaptor
1. If the included power adaptor is interchangeable plug type, choose
the included adaptor plug that ts the type of AC outlet used in your
region. Follow the image to put the adaptor plug into the grooves of
the power adaptor unit and rotate the adaptor plug clockwise to lock.
If the included power adaptor is not interchangeable plug type, skip
this process.
2. Connect the adaptor to the DC 12V jack of this instrument.
3. Plug the adaptor into an AC outlet.
4. Press the [POWER] switch, the LCD screen turns on, indicating the
instrument is powered on.
5. If you are ready to turn o the instrument, press and hold the [POW-
ER] switch again.
Notes:
1. The power to the instrument will be turned o automatically after a
pre~determined amount of time has passed since it was last used
for playing music, or its buttons or controls were operated (Auto O
function). If you do not want the power to be turned o automatically,
disengage the Auto Off function (p. 23).
● The recorded song and the registered memory will be lost when the
power turns o.
● To restore power, turn the power on again.
2. For your safety, please unplug the instrument when it is not in use or
during a thunderstorm.
Using Batteries
This instrument requires six AA size or equivalent alkaline batteries for
power supply.
1. Open the battery compartment cover located on the bottom of the
instrument.
2. Insert the batteries. Carefully follow the polarity markings on the
cabinet.
3. Replace the compartment cover. Make sure it locks rmly in place.
Notes:
1. Do not mix used and new batteries.
2. Always use same types of batteries.
3. Remove the batteries from the instrument when it is not being used
for an extended period of time.
4. When turning the unit over, be careful so as to protect the buttons and
knobs from damage. Also, handle the unit carefully; do not drop it.
Setting a Music Rest
A music rest is supplied with the instrument. You can easily attach it by
inserting it into the slots at the rear of the panel.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
