26
Listening to Songs
Internal songs 6–65 do not contain a performance in the rhythm/accompaniment part
(Track [R] button). If you press a track button that does not contain a performance, it
will not light.
Here’s how to adjust the volume that a part will have after you’ve pressed a track button
to mute the playback while playing back a song.
The FP-4 lets you play back a specific part at a reduced volume so you can use that part
as a “guide” for your own playing.
1.
Select the song that you want to play (p. 22, p. 27).
2.
Hold down a track button and use the [-] [+] buttons to specify the volume
that the track will have when its playback is muted.
The volume for when the playback is muted will be shown while you hold down the track button.
fig.d-Guide30.eps
The track mute volume can be set to any value from 0 to 80.
When you turn off the power, the track mute volume setting will return to “0.”
You can also adjust the track mute volume by turning the [Balance] knob while you
hold down the track button.
Determining the Volume of a Muted Track
NOTE
When the following appears in the display
If there is the performance you recorded but have not yet saved, the following display will
appear if you attempt to select a song.
fig.d-dEL.eps
You cannot play back an internal preset song if memory contains an unsaved song.
If you want to delete your performance and play back the internal preset song, press the
[Rec] button. If you don’t want to delete your performance, press the [Play] button. If you
want to save your recorded performance, refer to “Saving the Songs You Record” (p. 76).
NOTE
FP-4-e.book 26 ページ ２００７年５月２４日 木曜日 午後７時１０分
To Next Page
Loading...
Need help?
General
