72
Recording
FP-4’s Recorder has three Track buttons.
When you press the [Rec] button, all Track buttons are set to be recorded, but by
selecting Track buttons that are not to be recorded, you can then record only on the
specific Track buttons you want.
You can play each hand of your performance separately, for example recording the left-
hand part on the Track [1] button and the right-hand part on the Track [2] button. You
can also re-record just a specific part of a previously recorded performance.
fig.Panel-RecTrack.eps
If you’re recording a new song, select “USr” as described in steps 1–2 of “Recording a New
Song” (p. 66). If you decide to re-record an existing song, select that song.
Performance Settings
1.
Press the [Rec] button.
The [Rec] button will light, the [Play] button will blink, and the instrument will enter recording
standby mode.
If you decide not to record, press the [Rec] button once again.
2.
Press the button of the track you want to record, so the button is blinking.
Recording Selected Track Buttons
Track buttons
Description
Blinking
The performance will be recorded.
If performance data already exists, the existing performance will be erased
and replaced as the new recording proceeds.
Lit
The performance will not be recorded.
During recording, the performance located at this track button will play back.
Unlit
The performance will not be recorded.
This track does not contain performance data.
FP-4-e.book 72 ページ ２００７年５月２４日 木曜日 午後７時１０分
To Next Page
Loading...
Need help?
General
