Roland FP-4 User Manual

42
Performing
You can add liveliness to the sound to give it superb clarity and distinctness.
fig.Panel-SoundControl.eps
1.
Press the [Sound Control] button so it’s lit.
The Sound Control function is switched on, enlivening the sound.
2.
While holding down the [Sound Control] button, press the [-] or [+] button
to change the type.
fig.d-1.eps
Turning Off Sound Control
1.
Press the [Sound Control] button so its light is turned off.
You can have the FP-4 remember whether the [Sound Control] button should be on or
off when you turn on the power (p. 84).
For some sounds, this may cause distortion. If the sound distorts, refer to “Adjusting the
Volume (Master Gain)” (p. 85).
The Sound Control function is not applied to the sounds of external devices connected
to the Input jacks.
Adding Liveliness to the Sound (Sound Control)
Setting
Type Description
1 Sharp
Creates a sound with boosted bass and treble.
2
Clear
Produces a sound with chords in the low registers that are clear and distinct.
3
Power
Creates a sound with boosted bass.
NOTE
NOTE
FP-4-e.book 42 ページ ２００７年５月２４日 木曜日 午後７時１０分

Roland FP-4 Specifications

General

Polyphony	128 voices
Rated Power Output	12 W x 2
Effects	Reverb, Chorus
Recorder	Approx. 30, 000 notes
Display	3-digit 7-segment LED
Connectors	MIDI connectors (IN, OUT)
Power Supply	AC adaptor (included)
Included Accessories	AC Adaptor Power Cord Music Rest
Speakers	12 cm x 2