94
Connecting Audio Equipment
By connecting audio equipment to the FP-4, you can listen to its sound from the speakers
of your audio system, or listen to sound from your audio system via the FP-4’s speakers.
To make connections, use an audio cable with 1/4” phone plugs.
Before connecting this unit to other devices, turn off the power to all units. This will help
prevent malfunctions and/or damage to speakers or other devices.
Some connection cables contain resistors. Do not use cables that incorporate resistors
for connecting to this unit. The use of such cables can cause the sound level to be
extremely low, or impossible to hear. For information on cable specifications, contact
the manufacturer of the cable.
If you’ll be playing the FP-4 in a larger space, such as in a concert, you can connect
amplified speakers to make the sound louder.
Make connections as shown below.
fig.cnct-speaker1.eps
• Sound will still be heard from the FP-4’s internal speakers even if you connect external
speakers.
If you don’t want to hear the internal speakers, turn the [Speaker switch “Off” so that sound
will be heard only from the external speakers.
* If headphones are connected, no sound will emanate from the FP-4’s speakers even if the
[Speaker] switch is in the “On” position.
* If you connect the FP-4 to an external device (such as an external speaker) in monaural, it
may sound differently than when using a stereo connection.
Sending the Sound to External Speakers
NOTE
NOTE
Amplified Speakers, etc.
Input (Line In) jacks
Output jacks Speaker switch
FP-4-e.book 94 ページ ２００７年５月２４日 木曜日 午後７時１０分
To Next Page
Loading...
Need help?
General
