Roland FP-4 User Manual

41
Performing
1.
Press the [Display] button several times so it’s lit in orange.
The tempo is displayed.
fig.d-Tempo.eps
2.
Press the [-] or [+] button to adjust the tempo.
The tempo is set in terms of the value of a quarter note, with possible values ranging from 10 up
to 500.
Each time you press the [Display] button, the display will alternate between showing the currently
selected tone number, the currently selected song number (a “U” or “P” is shown before the
number), the currently selected rhythm number (an “r” is shown before the number), and tempo.
If you press the [Display] button while using Session Partner, the rhythm number, tempo, and tone
number will be alternately shown.
The volume of the metronome can be adjusted, with ten volume levels available.
This is set to “5” when the instrument is turned on.
1.
While holding down the [Metronome] button, press the [-] or [+] button to
adjust the volume.
The display will indicate the metronome volume.
fig.d-MetroVol.eps
When the metronome volume is set to “0,” the metronome sound does not play.
You can also adjust the volume of the metronome by turning the [Balance] knob while
you hold down the [Metronome] button.
Changing the Tempo
Button
Display
Unlit
Tone Number
Green Song Number
Red Rhythm Number
Orange Tempo
Changing the Volume
NOTE
FP-4-e.book 41 ページ ２００７年５月２４日 木曜日 午後７時１０分

Roland FP-4 Specifications

General

Polyphony	128 voices
Rated Power Output	12 W x 2
Effects	Reverb, Chorus
Recorder	Approx. 30, 000 notes
Display	3-digit 7-segment LED
Connectors	MIDI connectors (IN, OUT)
Power Supply	AC adaptor (included)
Included Accessories	AC Adaptor Power Cord Music Rest
Speakers	12 cm x 2