32
Performing
Turning Off Split Play
1.
Press the [Split] button so its illumination is turned off.
The [Split] button’s indicator light goes out and the upper tone becomes the tone for the entire
keyboard.
You can vary the volume-level balance of the two tones. Take a look at “Changing the
Volume Balance for Dual Play and Split Play” (p. 34).
When you switch from Dual Play (p. 29) to Split Play, the Upper Tone used in Dual
Play is selected as the Upper Tone for Split Play.
You can specify which part is to have priority when the effects assigned to the Upper
Tone and Lower Tone differ. Refer to “Setting the Part to Which Effects Are Added” (p.
84).
Changing the Upper Tone
1.
Press the Tone button to choose a tone group.
2.
Press the [-] or [+] button to select a variation tone.
Changing the Lower Tone
1.
Hold down the [Split] button and press the Tone button to choose a tone
group.
2.
Hold down the [Split] button and press the [-] or [+] button to select a
variation tone.
You can change the pitch of the Lower Tone an octave at a time. Refer to “Changing
the Pitch of the Lower Tone in Octave Steps (Octave Shift)” (p. 87).
Switching Tone Groups and Tone Variations
FP-4-e.book 32 ページ 2007年5月24日 木曜日 午後7時10分