Roland System-8 - Viewing the System Version (VERSION INFO); Viewing Plug-Out Information (PLUG-OUT INFO)

26
Viewing Plug-Out Information (PLUG-OUT INFO)
Here’s how to view information on the currently loaded plug-outs.
1. Press the [MENU] button.
2. Choose “PLUG-OUT INFO” and press the [ENTER]
button.
Information on the currently loaded plug-outs is shown.
PLG1:Ver. 1.02À
JUPITER-8
3. Use the cursor [
K
] [
J
] buttons to select the MODEL
button (PLUG-OUT 1–3) to be shown.
MEMO
From “PLUG-OUT 3,” you can then press the cursor [
J
]
button to view pre-load plug-out information for PLUG-OUT1
and 2 in the same way.
ÄPRE1:Ver. 1.02À
JUPITER-8
What does pre-load mean?
These are plug-outs that are already installed in the SYSTEM-8.
If you later installed a dierent plug-out by overwriting a pre-load
plug-out, removing the plug-out you installed will bring back the
pre-load plug-out.
&
“Removing a PLUG-OUT (PLUG-OUT REMOVE)” (p. 29)
Viewing the System Version (VERSION INFO)
Here’s how to view the version of the SYSTEM-8’s system program.
1. Press the [MENU] button.
2. Select “VERSION INFO” and then press the [ENTER]
button.
The SYSTEM-8’s version is shown.
VERSION INFO
Version 1.10