38
MODEL SOLU COMP II SECTION 7.0
MAINTENANCE
SECTION 7.0
MAINTENANCE
7.1 OVERVIEW
7.2 REPLACEMENT PARTS
7.1 OVERVIEW
The Solu Comp II analyzer needs little routine maintenance. The calibration of the analyzer and sensor should
be checked periodically. To recalibrate the analyzer and sensor, see Section 6.0.
Clean the analyzer case and front panel by wiping with a clean soft cloth dampened with water ONLY. Do not
use solvent, like alcohol, that might cause a buildup of static charge.
7.2 REPLACEMENT PARTS
Many components of the analyzer are replaceable. Refer to the table below to find the correct parts diagram.
Model Description See Figure
1055pH-10 Panel mounting enclosure 7-1
1055pH-11 Pipe/surface mounting enclosure 7-2
To Next Page
Loading...
