Rosemount SOLU COMP II - Page 57

MODEL SOLU COMP II INDEX
INDEX (cont’d)
OUTPUTS
Assigning sensors and measurements to outputs...................................................................... 17-18
Assigning values to the low and high current outputs ................................................................ 18
Choosing 0-20 mA or 4-20 mA................................................................................................... 18
Choosing normal or logarithmic outputs..................................................................................... 18
Dampening.................................................................................................................................. 17-18
REDOX (DEFINITION)...................................................................................................................... 22
REPLACEMENT PARTS................................................................................................................... 38-40
SECURITY CODE
Changing the security code........................................................................................................ 24
Forgotten security code .............................................................................................................. 14
SIMULATING INPUTS....................................................................................................................... 45-47
SOFTWARE VERSION ..................................................................................................................... 12
SPECIFICATIONS............................................................................................................................. 1-3
STANDARDIZATION (see also Calibration) ...................................................................................... 35
TEMPERATURE
Calibration................................................................................................................................... 29-30
Changing from °C to °F .............................................................................................................. 24
Choosing automatic or manual temperature compensation....................................................... 23-24
Choosing a solution temperature correction............................................................................... 22-23
TROUBLESHOOTING
Alarm relay problems.................................................................................................................. 6
Calibration problems................................................................................................................... 42-45
If fault message is showing......................................................................................................... 41-42
Interpreting glass and reference impedance readings ............................................................... 43
Output problems ......................................................................................................................... 45
UNITS
Changing from °C to °F .............................................................................................................. 24
Changing from pH to ORP or Redox.......................................................................................... 22-23
WIRING
Power, output, and alarm connections........................................................................................ 10-11
Use of conduit............................................................................................................................. 9
Wiring sensor to analyzer (see also sensor instruction sheet)................................................... 10-11