RosRoca Olympus Mini - Page 109

INDEX
I‑1
OM1R-SM-GB01R
I index
C
Cleaning — 5-3
Body drain — 5-4
Cleaning the leachate tank — 5-6
Cleaning the light curtain units — 5-6
Daily cleaning — 5-5
Drains — 5-4
Pressure washing — 5-6
Tailgate drains — 5-4
D
Daily checks — 3-3
Daily safety check ‑ safety light curtain — 3-26
Daily safety checks ‑ refuse collection body — 3-3
Daily safety checks ‑ waste container lifting device
— 3-22
G
General specification data — 8-3
Dimensions — 8-5
Hydraulic oils and greases — 8-4
Hydraulic pressures — 8-3
Noise level — 8-3
Typical operation times — 8-3
Cycle time — 8-3
Ejection plate — 8-3
Tailgate raise/lower — 8-3
H
Health and safety — 2-3
Cleaning a vehicle — 2-12
Pressure washing — 2-12
First aid and emergency treatment — 2-6
Burns — 2-6
Carbon monoxide poisoning — 2-6
Contact with and/or ingestion of fluids — 2-6
Cuts and wounds — 2-6
Workshop first aid equipment — 2-6
Hydraulic and pneumatic systems — 2-14
Returning the vehicle to service — 2-14
Introduction — 2-3
Precautions and protection for personnel — 2-4
Personal hygiene — 2-4
Protective clothing — 2-4
Safety symbol, warnings, cautions and notes —
2-3
Trained personnel — 2-3
Use of these instructions — 2-3
Vehicle electrical systems — 2-12
Disconnection and reconnection of electrical
components — 2-13
General electrical precautions — 2-12
Welding on or near the vehicle — 2-13
Working at high level — 2-5
Workshop precautions, procedures and practices
— 2-7
Access and lifting equipment — 2-10
Cleaning of equipment — 2-10
Contact with plastic material residues after
fires — 2-11
Environmental protection precautions — 2-10
Fasteners — 2-9
Fuel, oil, lubricants, degreasants and filters —
2-11
General workshop precautions — 2-8
Hot components — 2-9
Immobilising the vehicle — 2-8
‘Live’ work — 2-9
Manual handling and movement of loads —
2-10
Material safety data sheets — 2-7
Moving or rotating parts — 2-9
Protecting vehicle components during grinding,
drilling and welding — 2-9
Responsible technician, the Key Holder — 2-8
Solvents — 2-11
Welding on or near the vehicle — 2-9
Work place cleanliness — 2-8
Hydraulic system oil level — 4-3
To check hydraulic system oil level — 4-3
Topping up hydraulic oil — 4-8
I
Introduction — 1-3
Immobilising the vehicle prior to service
procedures — 1-3
Safety precautions — 1-3