RosRoca Olympus Mini - Page 28

13. Switch the ignition ‘on’ only, do not start the
engine.
• The control screen should initialise and then
display the ‘Body system off’ mode.
4713-OM1-R-GB-G1
01.06.2013
Hyd Oil Temp
09:00:00
32
o
C
0 No errors
0 No errors
0 No errors
I
0
II
III
14. Switch on all the vehicle lamps, including fog lamps
(if fitted).
• Check that the lamps and their associated
warning lamps illuminate when switched ‘on’
and extinguish when switched ‘off’.
15. Operate the footbrake.
• Check that all the brake lamps illuminate when
the pedal is pressed and extinguish when the
pedal is released.
16. Switch on the warning beacons.
• Check that the warning beacons and their
associated warning lamps operate correctly
when switched ‘on’ and extinguish when
switched ‘off’.
• If separate cab beacon switch is fitted check
that it over‑rides function on cab control panel.
4642-OM1-R-GB-G1
2748-DS002-OL1-D-DE-G3
01.06.2013
Hyd Öl Temp Grad C
09:00:00
32
o
C
0 Keine Fehler
0 Keine Fehler
0 Keine Fehler
01
.
06
.
2013
Hyd Öl T
e
m
p
Grad
T
T
C
09
:
00
:
00
32
o
C
0
Ke
in
e
F
e
hl
e
r
0
K
e
i
ne
F
e
hle
r
0
Ke
in
e
F
e
hl
e
r
17. Make sure that the parking brake is applied and
Neutral ‘N’ is selected.
18. Engage the PTO (see chassis cab manufacturer’s
operating instructions).
19. Start and run the engine.
20. Check the warning panels and instrumentation for
any indications of system malfunctions.
• The ‘Low air pressure’ warning buzzers should
not be sounding.
21. Turn the ‘Body main’ switch ‘on’.
• The screen should display the ‘Body system
run’ mode and ‘System on’ pictogram.
2748-DS003-OL1-D-GB-G2
Hyd Oil Temp 32
o
C
01.06.2013 09:00:00
0 No errors
0 No errors
0 No errors
• If any warning pictograms are displayed on
the screen, report to supervision immediately
and do not proceed any further with the daily
inspection.
DAILY CHECKS
3‑4
OM1R-SM-GB01R
3