ROTAX 125 MAX evo, Junior MAX evo, Mini MAX evo, Micro MAX evo
Configuration 125 Junior MAX evo, Mini MAX evo und Micro MAX evo:
S
ee Fig. 21.
Note: 125 Junior MAX evo, Mini MAX evo and Micro MAX evo do not have a RAVE
control unit. Please install the dummy plug (pos. 1) (part no. 666900, available as
spare part) to avoid entry of dirt and dust.
Fig. 21
Connect electric plug to ignition coil.
Use the tie wrap medium (pos. 1) to fix the wire of the ignition coil.
Attention: This step is necessary to avoid vibration of the wiring harness.
Fig. 22
Take the shift contact and make a loop (pos. 1), then fix with tie wrap (pos. 2). See
Fig. 23.
Tie wrap (pos. 2) must keep following wires together:
a) ECU wire
b) Ignition coil wire
c) Loop of shift contact wire
Page 14/53 Edition 07/2016
To Next Page
Loading...
