44/74
At the bottom of the screen the user can see the Encoding parameters for Audio and Video
components. After few seconds, this bar disappears from the screen, giving the user the full
screen view of the Video component.
Touching again the screen over the video content, will switch the view back to the Services
List.
5. Vpid and Apid: this row visualizes the Video and Audio PIDs for the selected service.
6. Miscellaneous information: in this box the meter collects all the misc information about the
selected service: Service ID, presence of Teletext and encryption status.
7. Transport Information: In the bottom status bar the meter displays the basic Transport
Stream parameters: TS ID, Cell ID, Network ID and Network name.
When the selected service is a Radio, the video box will be empty while the Audio PID will be
decoded and diffused by the two embedded stereo loud speakers.
The MPEG Decoder could also be activated on the ASI input. In this case, the user should
activate the input via the meter's configuration menu, switching ON the ASI INPUT:
From that point, on the MPEG decoding principle, is the same as explained before.
To Next Page
Loading...
