EN-5Manual | TM3-Primus Safety Instructions
EN
• Only use with the delivered USB connecting cable and the delivered
power supply model SYS 1460-1105-W2E USB, manufactured by
Dehner Elektronik GmbH, which both are specifi ed for this product
• Removing the USB conntecting cable disconnects the product from
the power supply coming from a computer or the external power sup-
ply. Do not block the USB cable or the power supply; it must remain
accessible to the user at any time.
• Connect and disconnect properly. Use only connectors specifi ed for
this product and fi x them tight before use.
• Observe all terminal ratings and markings on the product. Consult the
operating manual for further ratings information before making con-
nections to this product.
• Do not apply a potential to any terminal that exceeds the maximum
rating of that terminal.
• Avoid exposed circuitry. Do not touch exposed connections and com-
ponents when power is present.
• Turn off and disconnect the power supply immediately it the unit pro-
duces unusual smells, noises or smoke, or if foreign substances (e. g.
liquids) or foreign objects enter the unit.
• The unit shall not be exposed to excessive heat such as sunshine, fi re,
or similar.
• Do not cover the unit and do not place any objects or anything contai-
ning liquids on it.
• Do not insert your fi ngers or any other objects into the housing.
• Do not operate without cover plates or panels.
• Do not operate with suspected failures. If you suspect there is damage
to the unit, have it inspected by qualifi ed service personnel.
• Do not use this apparatus near water.
• Do not operate in wet/damp conditions.
• Do not operate in explosive atmosphere.
• Do not operate in dusty environments.
To Next Page
Loading...
