4 | Instruments | 4.9 | Numeric InstrumentEN-58
Manual | TM3-Primus
4.9 | Numeric Instrument
Instrument
The Loudness Numeric instrument provides numerical readouts of the
following loudness measurements:
• M (Momentary): Summed momentary loudness measurements of the
individual channels using an integration time of 400
ms.
• S (Shortterm): Summed loudness measurement using an integration
time of 3 s and a sliding window.
• I (Integrated): Overall program loudness between start and end
points that are entered manually. Use the Start, Stop
and Reset Loudness buttons to execute this measu-
rement.
• LRA: Loudness Range
• TPmax: The highest measured True Peak value in dBTP
If needed, the numerical readouts of these individual loudness measure-
ments can be activated or disabled individually. The values of current run-
ning measurements for I, LRA, and TPmax values will be colored green,
those of stopped measurements yellow. If values are exceeding the upper
limits, they will be colored red.
State of the measure-
ments:
green: running
yellow: stopped
red: exceeded
Current Momentary-
value M
Current Shortterm
value S
Current Integrated
value I
Current LRA value
Maximum True Peak
value TPmax