63
Configuring the Access Point
Configuring Device Settings
5. Under Login remote authentication, click the TACACS+ State box to enable
TACACS+ authentication, if required. Terminal Access Controller Access-Control
System Plus (TACACS+) is an AAA protocol used to authenticate administrator
login to this device. Users can be authenticated/authorized to monitor, operate
or configure this device. Default is disabled. Administrators can be assigned any
of the following three administration privilege levels:
• Super Admin (Perform all configuration and management tasks)
• Operator Admin (Change settings affecting single AP's only)
• Monitoring Admin (Monitoring and viewing operation status only)
6. If TACACS+ server state is enabled, then configure the TACACS+ server:
• TACACS+ server: IPv4 or IPv6 server address.
• TACACS+ port: 49 is the default, but it can be set to any available TCP port.
• TACACS+ Service: Login name.
• Share Key: TACACS+ Password.
• Confirm Share Key: TACACS+ Password.
7. Click Update Settings to save and apply your changes.
To Next Page
Loading...
