Ruijie RG-S5750-H Series - Page 24

Hardware Installation and Reference Guide Product Overview
20
LED
Panel
Identification
State
Meaning
System status
LED
Blinking green
(3 Hz)
The switch is being initialized with 3Hz
blinking.
Continuous blinking indicates errors.
Blinking green
(10Hz)
Supports remote on/off to locate the
switch.
Solid green
The switch is operational.
Solid yellow
Temperature alarm:
1. Temperature of inlet/outlet air
exceeds the normal operating
temperature range.
2. The power supplies cannot support
the whole system.
Check the working environment of the
switch and power supplies immediately.
Solid red
The switch is faulty. For details, see the
chapter “Troubleshooting”.
Power status
LED
PWR1/PWR2
Off
The power module is not in place or not
receiving power.
Solid green
The power module is in place and can
supply power.
Solid red
The redundant power is faulty or the AC
power cord is not connected.
MGMT port
status LED
MGMT
Off
The port is not connected.
Solid green
The port is connected at 1000 Mbps.
Blinking green
The port is receiving or transmitting
traffic at 1000 Mbps.
Solid yellow
The port is connected at 10/100 Mbps.
Blinking yellow
The port is receiving or transmitting
traffic at 10/100 Mbps.
10GE SFP+ port
status LED
49F-52F
Off
The port is not connected.
Solid green
The port is connected at 1/10 Gbps.
Blinking green
The port is receiving or transmitting
traffic at 1/10 Gbps.
GE SFP port
status LED
1F-48F
Off
The port is not connected.
Solid green
The port is connected at 1000 Mbps.
Blinking green
The port is receiving or transmitting
traffic at 1000 Mbps.
Solid yellow
The port is connected at 100 Mbps.
Blinking yellow
The port is receiving or transmitting
traffic at 100 Mbps.