Ruijie RG-S5750-H Series - Preparation before Installation; Safety Suggestions

Hardware Installation and Reference Guide Preparation before Installation
39
2 Preparation before Installation
2.1 Safety Suggestions
To avoid personal injury and equipment damage, please carefully read the safety suggestions before
you install the RG-S5750H series.
The following safety suggestions may not cover all possible dangers.
This equipment is not suitable for use in locations where children are likely to be
present.
2.1.1 Installation
 Keep the chassis clean and free from dust.
 Do not place the equipment in a passage.
 Do not wear loose clothes or any other things that may be caught by the chassis during installation
and maintenance.
 Turn off all power supplies and remove the power sockets and cables before dismantling the
cabinet.
2.1.2 Movement
 Do not frequently move the device.
 While moving the device, keep its balance and avoid your legs, feet and back from being hurt.
 Before moving the device, turn off all power supplies and dismantle all power modules.
2.1.3 Electricity
 Observe local regulations and specifications when performing electric operations. Relevant
operators must be qualified.
 Carefully check any potential danger in the working area, such as ungrounded power supply,
unreliable grounding of the power supply, and damp/wet ground or floor.
 Find out the location of the emergency power supply switch in the room before installation. First cut
off the power supply in the case of an accident.
 Do not maintain the switch that is powered-on alone.
 Make sure that the power is turned off when necessary.
 Do not place the equipment in a damp place. Do not let any liquid enter the chassis.
Any non-standard and impropriate electric operations may cause an accident such as a fire or
electrical shock, thus causing severe even fatal damage to human bodies and equipment.