Hardware Installation and Reference Guide Preparation before Installation
44
Cables must be connected to interfaces inside the room to prevent damage to the device’s signal
ports caused by over-voltage and over-current generated by thunder and lightning.
2.3 Precautions for Fiber Connections
Before you connect the fibers, check that the optical connector type and fiber type match the optical
interface type used. In addition, pay attention to the Tx and Rx directions of the fiber. The Tx end of this
device should be connected to the Rx end of the peer device, and the Rx end of this device to the Tx
end of the peer device.
2.4 Installation Tools
List of Installation Tools
Phillips screwdriver, flat-head screwdriver, related electric cables and
optical cables, bolts, diagonal pliers, straps
RG-S5750H is not provided with a tool kit. Please prepare tools on your own.
To Next Page
Loading...
Need help?
General