Sacher Lasertechnik Pilot PC - LD-Power Menu; Adjusting the power; Calibration Table

Sacher Lasertechnik
Group
User Manual Laser Diode Controller PilotPC 27
LD-Power Menu
In dependence on the Laser Mode (const current or const. power) the
photo diode current or the laser power could be adjusted/displayed.
Adjusting the power:
- Press the jog dial until the set value is highlighted
- adjust the power by turning the jog dial (power is immediately
changed)
- Press the jog dial until the set value is not highlighted
Calibration Table
To display the laser power a internal cross table is used.
This table is predefined on a special laser system but could be changed
by the user over the remote interface. You find a detailed description
how change the cross table in the programming manual.
I-LD: 1234,5 mA
POS I-MODE LIM
TEC -4000 mA
AD590 21,00
°
C
PZ FG CC EM
RM STA 12345
Photodiode[uA]
SET 1234.5
ACT -1234.5
Crosstable
PD-current
[uA]
Laser Power [mW]