SAF Integra-X - Page 32

INTEGRA-X User Manual WEB GUI
SAF Tehnika JSC 32
If you do not save configuration after modification, it will be lost after the FODU
restart
CLI commands
See Chapter 4 : COMMAND LINE INTERFACE
radio status
Use to show radio status.
radio power {A|B} <Tx power>
Use to set Tx power in dBm.
radio power {A|B} off
Disable Tx power permanently
radio frequency {A|B}
<frequency>
Use to set Tx frequency in kHz.
modem allowed show <profile
name>
Use to check modem concrete profile parameters.
modem configuration set
<profile name>
Use to set modem configuration – bandwidth, minimum
and maximum modulation.
modem configuration variant
{A|B}
Use to set modem A or B in single channel configuration
mode.
modem configuration set
factory
Use to reset modem settings to factory defaults –
bandwidth and modulation will be reset to a minimum.
radio factory
Use to reset radio settings to factory defaults – Tx power
will be disabled and frequencies set to the factory
defaults.
network port show info
Use to show the status of all ports.
network port show config
Use to show the configuration of all ports.
network port set <port> admin-
state {enable|disable}
Use to enable or disable particular port.