INTEGRA-X User Manual WEB GUI
SAF Tehnika JSC 71
CLI commands
See Chapter 4: COMMAND LINE INTERFACE
firmware info [<version>]
Use to show detailed information on current or specific
Integra-X firmware.
firmware install <version>
Use to install firmware version uploaded. Note that the
exact version name needs to be entered. Check available
firmware versions using command “firmware list”.
Use to list uploaded firmware versions.
firmware remove <version>
Use to remove firmware version uploaded. Note that the
exact version name needs to be entered. Check available
firmware versions using command “firmware list”.
Use to remove all uploaded firmware versions.
Use to check running firmware bank and bank that will
be used at the next boot.
Use to upload firmware file from the FTP directory.
firmware switch
{fs|fw1|fw2|toggle}
Use to define the bank that will be used at the next boot.
“fw1” and “fw2” subcommands set appropriate bank,
“toggle” forces to set another bank than the running one,
“fs” is factory defined emergency bank, which is used if
both “fw1” and “fw2” fail.
Use to the cold reboot radio unit.
To Next Page
Loading...