SAF Integra-X - Page 85

INTEGRA-X User Manual WEB GUI
SAF Tehnika JSC 85
CLI commands
See Chapter 4: COMMAND LINE INTERFACE
system service http
[{enable|disable}]
Use to show status or enable/disable HTTP service.
system service http port [<port>]
Use to show/change the port number for HTTP service.
system service https
[{enable|disable}]
Use to show status or enable/disable HTTPS service.
system service https port [<port>]
Use to show/change the port number for HTTPS
service.
system service redirect
[{enable|disable}]
Use to show status or enable/disable HTTP redirection
to HTTPS.
system radius status
Use to show RADIUS configuration status.
system radius {enable|disable}
Use to enable or disable RADIUS configuration.
system radius addr <IP_address>
Use to define RADIUS server IP address.
system radius port <port>
Use to define a port number of a RADIUS server. By
default port 1812 is defined.
system radius secret <psw>
Use to define a RADIUS server password.
system service ftp
[{enable|disable}]
Use to show status or enable/disable FTP service.
system service ssh status
Use to show the status of SSH service.
system service ssh
[{enable|disable}]
Use to enable/disable SSH service.
system service ssh port {set
<port>|reset}
Use to define/reset a port number of SSH service. By
default port 22 is defined.
system service telnet status
Use to show the status of TELNET service.
system service telnet
[{enable|disable}]
Use to enable/disable TELNET service.
system service telnet port {set
<port>|reset}
Use to define/reset a port number of TELNET service.
By default port 23 is defined.