- 13 -
2 - Installation
Wi-Fi wireless connection (WPS)
To connect your machine using the Wi-Fi wireless network (WPS), follow these steps:
1 Set the machine to WPS association mode by pressing the Setup button on the back of the machine.
2 Set Internet box to WPS association mode. For further information, refer to the Internet box manual.
3 The connection steps take place successively.
4 When the machine is switched on for the first time, a software updating operation can start automatically (see
the section “Maintenance menu”, page 28). Do not turn the device off during this operation, as it might not restart.
Once the software has been updated, the following messages are displayed alternately on the LCD screen:
5 Press the key, the following messages are displayed alternately on the LCD screen:
6 Log onto the service provider's website from your computer and go to your machine's settings page.
Depending on your service provider, you may have to enter a pin code in a field. If this is the case, please enter
the code value displayed on your machine as this pin code.
To complete the pairing process, in all cases press the web page "pairing" button.
Note that you have 1 minute from the onset of pairing on your machine to complete the pairing process on your
service provider's website. If this period is exceeded, you will need to repeat the complete pairing procedure.
7 Once pairing is complete, the machine is ready for use and the screen shown below is displayed
PAIRING NEEDED
PAIRING...
SERVICE - 1
LU IB1100E_EN.book Page 13 Mercredi, 15. mai 2013 9:01 09
To Next Page
Loading...