Salon Systems T-Max Manager - Page 11

T-Max® Manager/Plus and T-Max®3A/F/I User’s Guide Page 9
4) The following message will appear: GET PARAMS? If you just want to observe current
values, press Enter. If you want to send new values, press Next, then go to Step 6.
5) The following message will appear: WHICH PARAMETER? Enter the parameter number
from Table 1 followed by the Enter key.
The top line on the LCD display will show the bed number. The second line will show the
value for the parameter you checked. Press Clear to exit.
6) Press the Next button.
7) The following message will appear: SEND PARAMS? Press the Enter button.
8) The following message will appear: WHICH PARAMETER? Enter the parameter number
from Table 1 followed by the Enter button.
9) The following message will appear: SEND WHAT DATA? Enter the value that you want
to store in that timer followed by the Enter button. Press Clear to exit.