T-Max® Manager/Plus and T-Max®3A/F/I User’s Guide Page 33
4) Connect each T-Max® Slave Kit to each T-Max® Mgr/Plus and to the cable connected to
the first tanning room.
5) Apply power to the Master T-Max® Mgr/Plus
6) Refer to Section 5.2.1 and Set the Max. Slave Setting on the Master T-Max® Mgr/Plus.
7) Cycle power to the Master T-Max® Mgr.
Note: Each Slave T-Max® Mgr/Plus must be powered up before you power the Master T-
Max® Mgr/Plus. Each computer can be used to cancel a session, start a session, and monitor
all sessions. However, parameters (bulb hours, session counts, etc.) can only be monitored and
changed from the Master T-Max® Mgr/Plus.
9. T-MAX®3A/F/I OVERVIEW
Each T-Max®3A/F/I can individually control a tanning bed in the event of a front desk
failure. Operation is accomplished via front panel controls. The T-Max®3A/F/I comes fitted
with a wall plate and fits into a 4- wide wall box.
9.1 Installing the T-Max® 3A/F/I
Refer to Section 2.1.
9.2 Setting Parameters on the T-Max®3A/F/I
Note: If you are using a T-Max® Mgr/Plus and multiple T-Max®3A/F/Is, remove power from
the T-Max® Mgr/Plus then cycle power to each T-Max®3A/F/I. Keep power removed from
the T-Max® Mgr/Plus until all parameter changes are complete. Refer to Table 1 for
Parameter Numbers and Descriptions.
1) Apply power to the T-Max®3A/F/I
2) Press and hold the Start/Stop and Up buttons simultaneously on the T-Max®3A/F/I until a
.1 appears on the display. This should take 5-6 seconds. Release the Start/Stop button.
3) Press the Up or Down Button until the parameter number that you want is displayed.
4) Press the Start/Stop Button to observe the current value for that parameter.
The Display will show a number with a period in the lower center of the display. The
numbers will stop flashing and stay illuminated. The number shown is the current value
for that parameter.
For Lamp Hours, Session Counts, etc. the value displayed can be as high as 9999. To
display this value, the T-Max®3A/F/I will flash two numbers-three times, then two
numbers-three times, pause, two numbers-three times, two numbers-three times, pause,
etc. For example, if you are checking lamp hours (Parameter 6) and the display flashes the
numbers 53 three times, then 14 three times, pauses then repeats, then the total lamp hours
stored in that T-Max®3A/F/I is 5314.
5) Press the Up or Down button to change the parameter to the desired value.
To Next Page
Loading...