T-Max® Manager/Plus and T-Max®3A/F/I User’s Guide Page 7
5) Press the Start/Stop button on the display. A flashing number will appear. This is the
address that the timer is currently set to.
6) Press the Up or Down button until the desired address is displayed.
Note: When setting the addresses, remember these three rules:
• Set each T-Max®3A/F/I to a unique address.
• Do not set any T-Max®3A/F/I to address 00.
• If the period is flashing, you are over address 100.
7) Once the desired address is displayed, press and release the Start/Stop button. A solid .1 will be
displayed.
8) Press and hold both the Up and Down buttons until a 0 is displayed.
Repeat Steps 2-8 for each T-Max®3A/F/I that you are manually setting the address on.
4.2 T-Max® Mgr/Plus
1) Make sure all wiring is completed. Refer to Section 3 for wiring instructions.
2) Apply power to the T-Max® Mgr/Plus.
The T-Max® Mgr/Plus will scan for T-Max®3A/F/Is. An amber light will illuminate for
each T-Max®3A/F/I detected. Once scanning is complete, the light will turn green.
5. MANUAL OPERATION
5.1 Description
The T-Max® Mgr/Plus has 64 dual-colored lights showing bed status. Section 5.8 describes
the light indicators. A 16x2 LCD display on the upper right corner of the T- Max® Mgr/Plus
shows bed status and times. A 16 key keypad allows the user to control the salon.
5.2 Initial Configuration
5.2.1
Setting up the T-Max® Mgr/Plus.
1) Apply power to the T-Max® Mgr/Plus. The T-Max® Mgr/Plus will scan the network to
find all T-Max®3A/F/Is.
2) Press the Call/Menu Button. The following message will appear: SECURITY/CALL.
A sheet was provided showing the factory default settings for each security level and
security level descriptions.
3) The following message will appear: GET PARAMS? Press Next.
4) The following message will appear: SEND PARAMS? Press Next
5) The following message will appear: MGR PARAMS? Press Enter.
6) The following message will appear: MGR DELAY TIME. Enter the delay time in minutes,
followed by the Enter button.
To Next Page
Loading...