Salon Systems T-Max Manager - 5.3 Starting a Session; 5.4 Canceling a Session; 5.5 Pausing a Session; 5.6 Clean Room Indication

T-Max® Manager/Plus and T-Max®3A/F/I User’s Guide Page 11
779 – Real Time Clock (Not used on the T-Max® Series, but still reserved)
888 – Auto Addressing
911 – Emergency Call
999 – Rescanning the T-Max® Series
5.3 Starting A Session
You must be at Security Level 1, 2 or 3 to start sessions manually.
1) Press the bed number you want to start, followed by the Enter button.
2) Press the Time button. The display will read “Enter Session Time”
3) Enter the Session time you want followed by the Enter button.
If a delay other than 0 has been entered, the delay will count down on the display. If an
Infinite delay has been set up, the session time will show but will not count down.
DELAY will show for status. Once the customer presses the Start/Stop button on the T-
Max®3A/F/I in the room, the session will start. The display will show the session time
counting down and the status will say ON.
5.4 Canceling A Session
1) Press the bed number that you want to cancel, followed by the Enter button.
2) Press the Time button. The message “Enter the Time” will appear on the LCD display.
3) Press the Enter button (without entering any time).
If the clean room is enabled and the delay time has expired, DIRTY will appear on the
display. The Status LED will be Red. Once the clean room has been cleared, the display
on the T-Max® Mgr/Plus will show READY and the Status LED will turn Green.
5.5 Pausing A Session
To pause a session, press the Start/Stop button on the T-Max®3A/F/I at the tanning bed. The
flashing period will stop flashing and stay illuminated. The T-Max® Mgr/Plus display will
show PAUSE on the display.
Note: The session time will continue to count and display will reflect the remaining session
time.
To restart the session, press the Start/Stop button on the T-Max®3A/F/I. The period will
continue flashing and the Status on the T-Max® Mgr/Plus will change to ON.
5.6 Clean Room
Once the session time has elapsed or has been canceled, the display will show two periods
with no numbers, which is an indication that the room needs to be cleaned. Press and hold the
Up button on the T-Max® 3A/F/I in the tanning room until a 0 appears on the display to clear
the clean room. For a complete description of Clean Room, refer to Section 11.1.