T-Max® Manager/Plus and T-Max®3A/F/I User’s Guide Page 30
9) Repeat Steps 1-8 until all messages are recorded are recorded.
7. THE INTERCOM
7.1 Setting Up the Intercom
Install the Series as described in Section 2. Section 2.3 describes how to adjust the volume in each
T-Max® 3A/F/I in each room.
7.1.1
Adjusting the Volume on the T-Max® 3A/I/Master
1) Press the Call/Menu button on the T-Max® Mgr/Plus. The LCD display will read as
follows: SECURITY/CALL
2) Press 1 followed by the Enter button.
3) Have a person go into room 1 you called and start talking.
4) Press the Volume Up or Down button on the T-Max® 3A/I/Master to adjust the volume.
5) Press the Volume Up and Down buttons on the T-Max® 3A/F/I simultaneously to save the
volume level.
7.2 Calling a Room from the Front Desk
1) Press the Call/Menu button on the T-Max® Mgr/Plus. The LCD display will read as
follows: SECURITY/CALL.
2) Press the room number you want to talk to followed by the Enter button.
The light on the T-Max® 3A/I/Master will flash Red. The timer on the tanning room will
go to double dash ( -- ). The light on the T-Max® 3A/I/Master will flash red.
If Parameter 22 is set to a 1, the tanning bed will automatically turn off and the timer will
go to pause (the session time will continue to count down). If parameter 22 is set to a 0,
the tanning bed will stay on.
To talk to the room, press and hold the talk button on the T-Max® 3A/I/Master. Hold this
button while talking. Release the button to listen. No button needs to be pushed in the
room to talk.
Press Clear on the T-Max® Mgr/Plus to hang up the intercom. The display on the T-
Max® 3A/F/I will show the remaining session time and the light on the T-Max®
3A/I/Master will turn green.
7.3 Calling the Front Desk from a Room.
1) Press and release the Call button on the T-Max® 3A/F/I in the tanning room.
The T-Max® 3A/F/I will show two dashes. If parameter 22 is set to a 1, the tanning bed
will turn off and the timer will go to a Pause mode (session time will continue to count
down). The light on the T-Max 3A/I/Master will flash red.
To Next Page
Loading...