T-Max® Manager/Plus and T-Max®3A/F/I User’s Guide Page 36
11.2 Cool Down Mode
Cool Down mode is used for beds that require a time to cool down before the next session can
be run. This is primarily used by high-pressure beds. While the T-Max®3A/F/I is in Cool
Down Mode, a session can not be run until the cool down time has expired.
To enable Cool Down Mode, set parameter 13 to the time in minutes you want the cool down
time to last. Setting parameter 13 to 0 disables Cool Down Mode. (Refer to Section 5.2.6 if
you are using the T-Max® Mgr/Plus manually, Section 6.3.5 if you are using ADNET, or
Section 8.2 if you want to disable Clean Room at the T-Max®3A/F/I)
After the session ends, the T-Max®3A/F/I will go into Cool Down Mode. A single period will
be displayed on the T-Max®3A/F/I and T-Max® Mgr/Plus will show a flashing green light for
the duration of the cool down time. ADNET and the T-Max® Mgr/Plus display will show
Cool with the time counting down. If clean room is also enabled the clean room will be
displayed. ADNET and the T-Max® Mgr/Plus display will show Dirty and the light for that
room will be solid red , but the Cool Down time will be shown counting down. If the room is
cleaned before the cool down time has elapsed or if the clean room is disabled, a solid period
will be displayed on the lower center on the T-Max®3A/F/I. The T-Max® Mgr/Plus display
and ADNET screen will show Cool with the cool down time counting down. You cannot start
a session until the cool down time has elapsed.
11.3 T-Max® Monitors
The T-Max® Monitors are devices that allow the salon owner to check the status of all the
beds at any place in the salon. There are two kinds of T-Max® Monitors: The T-Max®
Monitor and the T-Max® Monitor/Plus.
The T-Max® Monitor has 64 dual colored lights to allow the salon staff to check the status of
up to 64 beds at a glance. The color codes are the same as the lights on the T-Max® Mgr/Plus.
The T-Max® Monitor can be connected anywhere in the T-Max® chain, so your staff does
not have to run to the front desk to see each bed’s status.
The T-Max® Monitor/Plus has 16 LED displays showing remaining session time. Multiple
T-Max® Monitor/Plus’s can be connected for large salons. The T-Max® Monitor/Plus can be
connected anywhere in the T-Max® chain. You can connect them at the front desk if you want
to glance over and see remaining session time, or you can place them anywhere else in the
salon so the cleaning staff can see how much session time is remaining for each room. Contact
your dealer for more information.
11.4 T-Max® Sentry™ (Optional)
The T-Max® Sentry™ is a current sensing device that detects when a bed is energized when it
should not be or is not energized when it should be. If you are not using a T-Max® Mgr/Plus ,
the T-Max®3A/F/I must be programmed with this option enabled at the factory. Contact your
dealer for this option.
Note: Remove power from the tanning bed when installing this option. We recommend that a
licensed electrician installs this option.
To Next Page
Loading...