18 Fan Coil FC600 Instruction Manual
• During program setting, long press will save all settings and exit to home display.
• Program schedule time is a 10 minute step.
• If the selected days of week are 1-5+6-7, after you set the schedule for 1-5, the Fan Coil will automatically
go to programming 6-7.
• If you are programming whole week the same - after you finish programing schedule for days 1-7, the
Fan Coil will exit program setting mode.
• If the selected weekday is Monday, after the program setting is finished, the unit will automatically enter
program setting of Tuesday, then Wednesday, Thursday, Friday, Saturday and Sunday, finally exit the
program setting mode.
• Long press or is only to change fast time and temperature.
• At any time of setting, long press to return to the home display while saving your settings.
• The selected item will not flash if it is being adjusted. Flashing will resume about 0.5 seconds after key
release.
• The unit will return to home display after 30 seconds if no key is pressed, storing the program settings
which have been made. The unit will run as per the new program settings.
• The starting time of the next program cannot be equal or earlier than the previous one. For example in
the first program starts at 8:00, the next has to start at least 8:10 etc.
During program setting, few notes:
To Next Page
Loading...
