Sam4s ER-265EJ - Delete PLU Functionality

116 • Program Mode Programming Sam4s ER-260EJ/256EJ OP Manual v1.20
Delete PLU
Note: Before a PLU can be deleted, all report information must be cleared. It may be necessary
to run a Z1 and Z2 PLU Report, and if the PLU is an inventory item, you must change the stock
to zero.
If PLU’s had been added to the database by using the NOT FOUND PLU function, RESET N.F
PLU must be issued. See page 66 for details.
Delete One PLU
1. From the PLU PROGRAMMING screen, use the CHARGE1 and the
CHARGE2 keys to select “2.DELETE” and press CASH or press 2 and CASH to
display the DELETE PLU screen:
DELETE
1.ONE PLU
2. Select “1.ONE PLU” (or press 1) and press CASH to delete an individual PLU. The
PLU NUMBER screen displays:
ENTER PLU #
0
3. Enter the number of the PLU you wish to delete and press CASH. The DELETE
message will print.
Delete PLU Range
1. From the PLU PROGRAMMING screen, use the CHARGE1 and the
CHARGE2 keys to select “2.DELETE” (or press 2 to view the option directly).
Press CASH to display the DELETE PLU screen:
DELETE
1.ONE PLU
2. Select “2.RANGE PLU” (or press 2) and CASH to delete a range of PLU’s. The
PLU NUMBER screen displays: Enter the number of FROM PLU# in the range you
wish to delete. Press CASH.
ENTER FROM PLU#
0
3. Enter the number of TO PLU# in the range you wish to delete.
ENTER TO PLU#
1
4. Press CASH to delete the PLU. The DELETE message will print.
5. Continue to delete another PLU’s or press CLEAR key until return to PROGRAM
MODE menu.