Sam4s ER-265EJ - Postamble; Endorsement

164 • Program Mode Programming Sam4s ER-260EJ/256EJ OP Manual v1.20
Postamble
The postamble is a programmable message of up to six lines (up to 32 characters per line) that
appears at the bottom of each receipt.
1. From the MESSAGES screen, select POSTAMBLE or press 2. Press CASH to display
the POSTAMBLE screen. There are 6 lines of message:
1.NO DATA
2.NO DATA
3.NO DATA
4.NO DATA
5.NO DATA
6.NO DATA
2. Use the CHARGE1 and the CHARGE2 keys to select the message line you wish to
program and press the CASH key.
3. Type the new message (up to 32 characters) using the overlay (or enter codes if code
method selected in system options). Press CASH to confirm the new line.
4. Continue to program additional Postamble lines or press CLEAR to return to the
PROGRAM MODE screen.
Endorsement
The Endorsement Message is a programming message of up to ten lines (up to 32 characters per line)
that prints when a check is endorsed on an optional slip printer.
1. From the MESSAGES screen, select ENDORSEMENT or press 3. Press CASH to
display the ENDORSEMENT screen. There are 10 lines of message:
1.NO DATA
2.NO DATA
3.NO DATA
4.NO DATA
5.NO DATA
6.NO DATA
7.NO DATA
8.NO DATA
9.NO DATA
10.NO DATA
2. Use the CHARGE1 and the CHARGE2 keys to select the message line you wish to
program and press the CASH key.
3. Type the new message (up to 32 characters) using the overlay (or enter codes if code
method selected in system options). Press CASH to confirm the new line.
4. Continue to program additional Postamble lines or press CLEAR to return to the
PROGRAM MODE screen.