Sam4s ER-260EJ/256EJ OP Manual v1.20 Service Mode Programming • 89
Function Key Assignment
Any programmable key location may be reprogrammed with a function from the list of available
functions on page 90 of this manual. The default program installs the functions as they are shown
with the standard key legends.
To change the function on a specific key:
1. Move the key to the S lock position to display the Service Mode menu.
2. From the Service Mode menu press CHARGE1 until “KEY ASSIGN” is selected
(or press 4 to view the option directly.)
3. Press CASH. The Key Assignment screen displays:
KEY ASSIGN
000
4. Enter a new key code from “Function key codes” on page 90 and press key location.
You can press the SUBTOTAL to print the key code table.
5. Press CASH to save the changes you have made and to return to SERVICE MODE.
6. The printer will print out a receipt showing all the changes made to the keyboard.
NOTES:
► Numeric keys (0-9), CLEAR, and CASH cannot be removed from the keyboard unless they have
been assigned to a new keyboard location. This protects the programmer from accidentally removing
keys that are required for register programming and operations.
► CHARGE1, CHARGE2 and VOID keys are used for navigating through the X – Z – P and S-
Mode. These key locations revert to their navigation operations, Cursor when used in the X – Z
– P and S-Mode.
► If you wish to program the CASH key, select it immediately after selecting KEY ASSIGNMENT
from the SERVICE MODE menu. After the initial key is programmed, the CASH key is used to
finalize the program.
To Next Page
Loading...
