Sam4s ER-265EJ - Employee Programming; Clerk Programming Reference

Sam4s ER-260EJ/256EJ OP Manual v1.20 Program Mode Programming • 155
Employee Programming
1. Move the key to the P lock position to display the Program Mode menu.
2. With the first option, “PLU” displayed, use the CHARGE1 and the CHARGE2
keys to select “5.EMPLOYEE” (or press 5 to go to the option directly.) Press CASH
to view the Employee selection screen.
ENTER CLERK #
(1-10) 0
3. Enter the clerk number of the employee you wish to program and press CASH.
4. Use the CHARGE1 and the CHARGE2 keys to select the Employee option you
wish to program. Use the table below for reference. Make changes as necessary.
5. Press the CLEAR key to finalize and return to the ENTER CLERK# screen.
Clerk Programming - Reference Information
Option Entry Description
1 NAME
Alpha numeric
16 character
You can program a descriptor for each clerk. The name you
program will print on the receipt in place of the default
CLERK #1-99. Type the descriptor using the Program Overlay
or by using the descriptor code method (see page 104.) The
overlay is automatically activated when the cursor is pointing
at the DESC field.
2 PASSWORD 6-digit number
If you are using a direct or code entry clerk system. The
number set here is the number you must use to sign on or out.
3 TRAIN CLERK Y or N Set to Y if you wish to be training clerk.
4 ALLOW X REPORTS Y or N If Y, if clerk can use X Reports menu.
5 ALLOW Z MODE Y or N If Y, if clerk can use Z mode.
6 ALLOW P MODE Y or N If Y, if clerk can use P mode.
7 ALLOW S MODE Y or N If Y, if clerk can use S mode.
8
ALLOW VOID
MODE
Y or N If Y, if clerk can use VOID mode.