Sam4s ER-265EJ - Train Mode Options Reference

Sam4s ER-260EJ/256EJ OP Manual v1.20 Program Mode Programming • 153
Option Entry Description
2
PROMPT WHEN E.J.
BUFFER IS FULL
Y or N
If the electronic journal is enabled above, select Y if you
wish to display a message to notify the operator when the
journal memory is full.
3
STOP OPERATIONS WHEN
E.J. BUFFER IS FULL
Y or N
If the electronic journal is enabled above, select Y if you
wish to stop operations when the journal memory is full.
4
SEND ONLY NEGATIVE
ENTRIES TO E.J.
Y or N
If the electronic journal is enabled above, select Y if you
wish to capture only transactions with negative entries.
5
SEND RESET REPORT TO
E.J.
Y or N
If the electronic journal is enabled above, select Y if you
wish to capture reset reports.
6 E.J PRINTING NEW
OLD
NEW: Prints electronic journal from lowest consecutive
number to highest.
OLD: Prints electronic journal from highest consecutive
number to lowest.
7 E.J PORT (0-3) 0-3
Choose a port for a remote printer to print electronic
journal reports instead of the register printer.
8
PRINT SMALL FONT EJ
REPORT
Y or N Select Y to print small font on EJ report.
TRAIN MODE Options
# Option Entry Description
1
OPEN DRAWER IN TRAIN
MODE
Y or N
Select N if you do not want the cash drawer to open
during training mode operations.
2
PRINT TRAIN MODE
TITLE
Y or N
When in training mode, the message "TRAIN MODE"
normally prints on each receipt. Select N if you wish to
delete this message.
3
SEND TO KP IN TRAIN
MODE
Y or N
You can choose whether to print or not print registrations
in training mode on kitchen requisitions.
4 TRAIN P/W 6 DIGIT
If you wish to use training mode, you must program a
password that you will use to enter training mode. The
password may be up to 6 digits.
5
PRT TRAIN CLERK
START/END MESSAGE
Y or N
Select N if you do not wish to print a message of train
clerk start or end.