3 Installation and Operation
SAM4S ER-380M/F SERIES 3-7
3-3 Operation
3-3-3 Initial Clear
1. Turn off the power switch.
2. Turn the mode switch marked ‘P’ to P-MODE.
3. Hold down the ‘SBTL’ key on the keyboard and turn on the power switch at the same time.
Figure3-10 Initial Clear Key & Print Sheet(ER380M)
3-3-4 All Clear
This step insures that the cash register is cleared of any totals or programming. After this procedure, the cash register is
ready for programming and operation.
WARNING: This is a one time procedure. Do not repeat this procedure after the cash register is
programmed, it causes all programs and totals to be erased and to be default.
Note : Service Mode is not marked in a mode painting part.
Service Mode spins the Mode Key once just in a Program Mode to the right direction.
And need “ C Key ” to execute a Service Mode.
1. Turn off the power switch.
2. Turn the Mode switch to Service Mode position.
3. Press and hold the CHECK key on key board and turn on the power switch at the same time.
4. When the buzzer beeps, press ‘FEED’, ‘#/NS’, ‘RECD ACCT’, and ‘CASH/TEND’ in sequence.
5. When memory is cleared, the register prints a message “RAM ALL CLEAR OK!
”
Figure3-11 All Clear Key Sequence & Print Sheet
DATE 01/31/2003 FRI TIME 16:01
= = = = = = = = = = = = = = = = = = = = = = =
RAM ALL CLEAR OK !
ER-380M EPROM INFO.
VERSION : STD 1.0
CHECKSUM : 887C
JANUARY 31 2003
= = = = = = = = = = = = = = = = = = = = = = =
CLERK 00 No.000001 00000
DATE 01/31/2003 FRI TIME 16:10
= = = = = = = = = = = = = = = = = = = = = = =
INITIAL CLEAR OK!
= = = = = = = = = = = = = = = = = = = = = = =
CLERK 00 No.000036 0000
To Next Page
Loading...
