What to do if Samson Control Unit flow set point not reached?
If the flow set point is not reached on your Samson Control Unit, a blocked control line could be the reason. Make sure to clean the control line and screw fittings. Alternatively, the strainer might be blocked, so clean the strainer.
Why is there a jerky control response on Samson Control Unit?
If your Samson Control Unit exhibits a jerky control response, it could be due to increased friction, potentially caused by foreign particles between the seat and plug. Remove any foreign particles and replace damaged parts to address this issue.
Why Samson Control Unit makes loud noises?
If your Samson Control Unit is producing loud noises, it might be due to high flow velocity or cavitation. Check the sizing and install a larger regulator if necessary.
What to do if my Samson Controller has an input signal failure?
If your Samson Controller experiences an input signal failure, especially when c31 = YES, the suggested solution is to check the signal source and wiring.
What to do if my Samson Controller is blocked?
If your Samson Controller experiences a blockage, especially when c51 = YES, you should check the attachment and valve, if necessary. Also check the actuator stem.
What to do if flow set point not reached on Samson Control Unit?
Details hazards and precautions related to severe personal injury, including bursting and electric shock risks.
Outlines potential risks such as hearing loss, burn injuries, and injury from pressurized components.
Describes potential risks of property damage due to incorrect handling, contamination, or unsuitable lubricants.
Details the information presented on the nameplates affixed to the valve and actuator.
Describes the nameplate specifications for the electric actuator component.
Illustrates the physical locations of nameplates on the regulator components.
Explains how to identify material numbers for valve, actuator, and electric actuator.
Discusses recommended additional fittings like pressure gauges, shut-off valves, and bypass lines.
Provides key technical specifications for the control valve, including pressure, temperature, and flow rates.
Instructions for checking the scope of delivery and identifying transport damage.
Guidance on safely removing packaging and protective caps before installation.
Details safe procedures and precautions for transporting and lifting the regulator.
Provides instructions and conditions for proper storage of the regulator, including elastomer care.
Specifies requirements for work position, pipeline routing, and environmental considerations.
Outlines necessary steps and checks before installing the regulator, including pipeline flushing.
Step-by-step guide for mounting the valve, actuator, and control line, including tightening torques.
Procedures for leak testing and pressure testing the installed regulator.
Guidance on insulating the regulator and associated piping for thermal control.
Steps to follow for initial startup or restarting the device after maintenance.
Instructions for safely starting the entire plant system with the regulator.
Explains how to adjust the flow rate set point using the restriction mechanism.
Detailed procedure for adjusting the flow rate for different valve and actuator sizes.
Lists common malfunctions, their possible causes, and recommended corrective actions.
Procedures for emergency situations, including handling malfunctions and returning to operation.
Steps to prepare the valve before performing maintenance or service tasks.
Overview of service tasks, including component replacement procedures.
Information on how to order spare parts, lubricants, and tools from SAMSON.
Procedure for detaching the actuator from the valve body.
Steps for safely separating the regulator from the pipeline.
Instructions for returning defective devices to SAMSON for repair.
Details relevant to the UK market, including importer information and conformity declarations.
Lists specified torque values for various components during assembly and servicing.
Information and diagrams for identifying and ordering spare parts for the valve.
Contact information and required details for SAMSON's after-sales support.
General| Connectivity | USB |
|---|---|
| Velocity Sensitivity | Yes |
| Aftertouch | No |
| Pitch Bend | Yes |
| Modulation Wheel | Yes |
| MIDI Out | No |
| Pedal Input | Yes |
| Compatibility | Mac, PC |
To Next Page
