Samson 3730-4 - Quick Start-up Guide; Mounting

EB 8384-4 EN 79
Operation
The condensed state is displayed represented
by the following icons:
Condensed state Positioner display
Maintenance alarm
Function check
Text e.g. tESting,
TunE or tESt
Maintenance required/
maintenance demanded
Process-related
malfunction/out of
specication
–
No message
–
If the positioner has not been initialized, the
maintenance alarm icon (
) is displayed as
the positioner cannot follow its set point.
If fault alarms exist, the possible source of
error is displayed in Code 49 onwards. In
this case, Err is displayed.
S
Example:
Error caused by pin position
Refer to the code list (section 14) for possible
causes and the recommended action.
8.3.1 Conrming error mes-
sages
Enable conguration:
If no settings are entered within 120 sec-
onds, the enabled conguration function be-
comes invalid.
Turn
g Code 3, display: No
Press
, Code 3 blinks.
Turn
 YES
Press
, display:
Conrming error message:
Turn
 Select the error code that you
want to conrm.
Press .
The error message is conrmed.
Note