Designation
Position
Parameter
Binary contact 1
SSP interface
Switch for
AIR TO OPEN/
AIR TO CLOSE
Volume restriction
Rotary pushbutton
Initialization key Cap or rotary switch Metal tag of proximity switch
Bar graph for
system deviation
or lever position
Units
Binary contact 2
Configuration
enabled
Fail-safe position
active
Maintenance required
Maintenance demanded
Readings on the display and their meaning
AUtO Automatic mode
CL Clockwise
CCL Counterclockwise
Err Error
ESC Escape
LOW w too small
MAN Manual mode
MAX Maximum range
NO Not available
NOM Nominal travel
O/C Type of application
on/off
ON On
OFF Off
RES Reset
RUN Start
SAFE Fail-safe position
SUb Substitute calibration
TunE Initialization in progress
YES Available
ZP Zero calibration
tEStinG Test function active
ää Increasing/increasing
äæ Increasing/decreasing
blinking Emergency mode
(error code 62
x signal, see p. 124)
blinking Not initialized
S blinking No valid setpoint exists or
valve has been moved to
fail-safe position by
SET_FAIL_ SAFE_POS
(see p. 94)
and together
AO Transducer Block is in MAN mode
Maintenance alarm/fault Manual mode Closed-loop operation Code
To Next Page
Loading...
