Samson 3730-4 - Page 97

Fault/diagnostic alarm
Value (hex) Status alarm acc. to
Profile 3.01
Initialization errors
x > range 0x80 GOOD_NON_SPECIFIC
Delta x < range 0x80 GOOD_NON_SPECIFIC
Incorrect attachment (mechanics/pneumatics) 0x80 GOOD_NON_SPECIFIC
Initialization time exceeded 0x80 GOOD_NON_SPECIFIC
Initialization/solenoid valve 0x80 GOOD_NON_SPECIFIC
Transit time too short 0x80 GOOD_NON_SPECIFIC
Pin position 0x80 GOOD_NON_SPECIFIC
Initialization running 0x80 GOOD_NON_SPECIFIC
Hardware errors
x signal 0x0C BAD_DEVICE_FAILURE
i/p converter 0x0C BAD_DEVICE_FAILURE
Hardware 0x0C BAD_DEVICE_FAILURE
Data memory 0xA4 GOOD_MAINT_REQ
Test calculation 0x0C BAD_DEVICE_FAILURE
Program loading error 0x0C BAD_DEVICE_FAILURE
Data errors
Control parameter 0xA4 GOOD_MAINT_REQ
Poti parameter 0xA4 GOOD_MAINT_REQ
Calibration error 0xA4 GOOD_MAINT_REQ
Internal device error 0x0C BAD_DEVICE_FAILURE
General parameters 0xA4 GOOD_MAINT_REQ
Options parameter 0xA4 GOOD_MAINT_REQ
Info parameter 0xA4 GOOD_MAINT_REQ
PA parameter 0xA4 GOOD_MAINT_REQ
Diagnostic parameter 0xA4 GOOD_MAINT_REQ
Extended diagnostics – EXPERT
+
Air supply
Perhaps modified TEST 0x80 GOOD_NON_SPECIFIC
Perhaps not enough TEST 0x80 GOOD_NON_SPECIFIC
Perhaps not enough 0x80 GOOD_NON_SPECIFIC
Working at full capacity 0x80 GOOD_NON_SPECIFIC
EB 8384-4 EN 97
PROFIBUS-PA communication